ALLIE Chrono Beauty Color Tuning UV 03 SPF50+ PA++++ [Sunscreen] [For Face] 40g (x 1)

Brand: ALLIE

Color: milky beige

Features:

• ■Cover uneven color and pores with this one product - no foundation UV
• ■SPF50+PA++++
• ■Super waterproof/friction proof
• ■Beach friendly formula
• ■Plastic reduction package (compared to our conventional products)

Details: Product introduction

This one product gives you an exquisite bare skin finish with no foundation and UV
Milky beige color correction effect covers uneven color and pores. This one product gives you an exquisite bare skin finish with no foundation and UV.

■Natural and unadorned citrus woody and patchouli scent
■Contains pore-blurring & UV-cut capsules *Contains pore-covering powder/UV-cutting ingredients/complexion-correcting pigments
■Remains shiny and hard to break for 8 hours *Data obtained (according to our research.Effects vary from person to person. *Skin finish due to makeup effect)
■Long lasting color
■Beach-friendly formula: Environmentally friendly design (water environment risk assessed)
■Using environmentally friendly materials for the exterior and container
■SPF50+/PA++++/UV water resistance★★
■Super waterproof
■Friction proof
■Sweat proof
■Not easily attached to masks, towels, etc.
■Can be removed with regular makeup cleansing
■Makeup base effect
■Contains serum ingredients (moisturizing): Sodium hyaluronate

Raw materials/components

Ingredients: Water, ethanol, diisopropyl sebacate, titanium oxide, triethylhexanoin, zinc oxide, dimethicone, glycerin, ethylhexyltriazone, BG, polysilicone-15, behenyl alcohol, bisethylhexyloxyphenolmethoxyphenyltriazine, hydrated silica, diethylaminohydroxybenzoylhexyl benzoate, hydrogenated lecithin, talc, Sodium lylate/Na acryloyldimethyltaurine) copolymer, triethoxycaprylylsilane, isohexadecane, (acrylates/polytrimethylsiloxy methacrylate) copolymer, polymer Resorbate 80, xanthan gum, Al hydroxide, isopropyl titanium triisostearate, fragrance, EDTA-2Na, sodium lauroyl aspartate, zinc chloride, sodium hyaluronate, iron oxide

How to use

How to use ●After preparing your skin with basic cosmetics, apply a small amount evenly and carefully to the face from the center to the outside. ●If the amount used is too small, sufficient UV protection effect will not be obtained. ●To maintain its effectiveness, please reapply frequently after wiping off sweat. ●Be careful not to get it directly on your clothes or accessories, and wait until it is dry before wearing it. ●Please close the cap properly after use. Estimated amount to use: ●Approximately 1.2cm in diameter when used on the entire face. How to remove ●Please carefully wash off with your usual makeup cleanser.

safety warning

●Do not use on areas with abnormalities such as wounds, swelling, or eczema. ●Carefully check that there are no abnormalities on your skin before use. If it does not suit your skin, or if you experience any abnormalities such as redness, swelling, itchiness, irritation, loss of color (vitiligo, etc.) or darkening during use, or if similar abnormalities occur when exposed to sunlight, discontinue use and consult a dermatologist. Symptoms may worsen if you continue to use it. ●Be careful not to get it in your eyes. If it gets in your eyes, rinse thoroughly immediately. ●Be careful not to get it on clothing, etc. When it gets dirty, immediately wash it carefully with detergent. Also, avoid using chlorine bleach as it may discolor (color) the stained area pink or other colors. ●Be careful where you store it to prevent children and people with dementia from accidentally ingesting it. ●Do not place in extremely hot or cold places, or in places exposed to direct sunlight. SPF is an index that shows the effect of protecting the skin from ultraviolet B waves, and PA is a classification that shows the effect of protecting the skin from ultraviolet A waves. SPF and PA indications are values ​​measured by applying 2mg per 1cm2 according to international standards. Please consider this as a guideline when selecting products.

Packing size: 6.7 x 3.3 x 1.3 inches